PLANTS, BUSHES AND TREES TRANSPLANTATIONBACK

      AQUASORBENT^TM products can be effectively applied in holes for plants, bushes and trees. They helpfully reduce the mortality rate due to transplanting shock and enhance root development and therefore bring more rapid growth and production. The dosage varies from 1 to 2 kg/m³ according to the sand content in the soil.

1.The illustration for a successful plantation:

    The hole for root is recommended as three times as the volume of the root.
    Mix 1 to 3 kg of AQUASORBENT^TM into filled soil According to the content of
      sand in soil. The more sand it contains, the moreamount of AQUASORBENT^TM
       is needed.
    Place the tree in its proper position and fill the hole with treated soil. Make
       sure that the AQUASORBENT^TM is well distributed along the root. Finally,
       cover the upper surface with 5 cm. of non-treated soil to avoid the damage
       byUV action and stagnation of water on the surface.
    Here specially notice that not to put unmixed dry AQUASORBENT^TM directly
       to the bottom of the hole. After hydration,the root of plant would be rotted
       by over water.

2.More choices for tree plantation

Dilly bag

    Put AQUASORBENT^TM into dilly bag (length 40-50cm, width 8-15cm) and then hydrate
       it completely in water.
    Put gel bag around root of trees and cover soil. This way is quite suitable for conditions
       of water lack or that water resource is far from tree plantation sites.
    You can take dilly bag out after water in gel goes inside soil and re-hydrate SAP again
       for many times. It is cost-saving and high efficiency.

3. Circum Furrow application

    Based on the shadow of trees, dig a circum furrow. To big trees, reduce distance to 50% of circum.
    Hydrate AQUASORBENT^TM in tank then take gel out.
    Put gels with fertilizers in furrow, then cover the soil.
    If necessary, irrigate soil.